STAFIX®STATIC

Offset

10,0022,00

Suurkuva UV- ja UV-LED-tulostimille. UV-INKJET -tuotteissamme kalvo on kiinnitetty kokonaan taustapaperiin kevyesti tarttuvalla (low-tack) liimalla. Kalvolle ei voi tulostaa liuotin- tai vesipohjaisilla väriaineilla.

STAFIX®STATIC is a glue-free sticker material that adheres to almost any clean, even surface with a static charge. the material adheres on average for 3 months and is easy to apply and removable without leaving any residue.
The material adheres on the unprinted side only.

STAFIX®STATIC OFFSET is available in white and clear and comes in sheets. The material consists of two layers:

  • 50 microns thick, polypropylene film. (Top layer)
  • 180 g/m2 cardboard backer. (Bottom layer)

The film is attached to the cardboard backer by two gluelines: A solid glueline in the front of the sheet, and a dotted glue line in the back of the sheet (see picture).

STAFIX®STATIC film is 100% recyclable as a grade 5 plastic and doesn’t release toxic gases into the environment if incinerated. The cardboard used for the backer is PEFC certified.

SHELF LIFE
In the sealed original package, unprinted STAFIX®STATIC sheets can be stored up to 12 months following our storage guidelines.

FORMATSHEETS / REAMSHEETS / PALLET
320 x 450mm2004000
480 x 650mm2002000 (in reams)
2500 (bulk)
707 x 1000mm2002000
Custom format2000

Store the unwrapped STAFIX®STATIC OFFSET in the original package at 25% to 50% relative humidity and 20°C to 27°C temperature. The material should remain sealed in the original wrap until the Stafix®STATIC material has warmed up to print-room temperature.

The print-room recommended relative humidity is 50% to 60% and the temperature 20°C to 27°C.

Orders over 800 will be delivered in bulk.

Do not use a Total Ink Coverage (TIC) greater than 240%. Use the Under Colour Removal (UCR) and Grey Component Replacement (GCR) if needed. Heavy deposits of ink should be avoided, especially near the edges of the artwork, to prevent the film from curling or rippling. Leave an unprinted border at the edges of the artwork if possible. Do not overlap a combination of two or more solid colours. Heavy layers of ink may cause the film to swell.

For pictures a raster of 60 – 70 l/cm is recommended.

Place the artwork close to the front of the sheet and leave an unprinted area on the tail of the sheet. The colour bar should be placed 2cm from the tail edge of the sheet.
Make sure that black text consists of only 100% black for better registration.

CLEAR MATERIAL
When printing an artwork on the clear material that will be used for window advertising, print the image mirror-wise and apply an additional covering white layer to reduce the transparency. Rasterize the covering white to 95%. Additionally to the covering white you can use 240% maximum TIC on the colour build.
The sticker or poster is always installed from the unprinted side to the glass. The material adheres only from the unprinted side.

Not all the presses have white inks available; consult with your printing house beforehand.

Please see the table below for the maximum printable area by product: